On 3/27/2013 8:39 AM, Les Mikesell wrote: > On Wed, Mar 27, 2013 at 6:36 AM, Robert Benjamin <benjie1 at cox.net> wrote: >>> See this FAQ entry: >>> >>> http://wiki.centos.org/FAQ/CentOS6#head-b67e85d98f0e9f1b599358105c551632c6ff7c90 >> Had read this FAQ many times and clicked "Configure Networking" and >> selected system eth0 and connect automatically. Bottom line is that it >> booted once but not a second time after logging off. Mentioned this I >> think. So that is where I have difficulties. In FAQ 2 above, the 'will >> start on boot in the future" is what id doesn't do. I can re-install >> again if that's necessary and hope it works this time. > If you can log in and use an editor in character mode you can fix it. > The change needed in /etc/sysconfig/network-scripts/ifcfg-eth0 will > be obvious once you get that far. But, it might be easier to > reinstall if you don't know how to do that. Since it is a new install > anyway you won't lose anything. In the CentOS forum under Software Support is my thread: Centos 6.4 won't install on reboot. Post number 27 or 28 lists the output I got from FAQ2 above from cat /etc /sysconfig/network-scripts/ifcfg-eth0 My guess is the most important line there is ONBOOT=yes Anyway, there are suggestions in the forum which I will follow and then post the results back to the forum. Thanks again.