On Mon, Nov 11, 2013 at 5:59 AM, hadi motamedi <motamedi24 at gmail.com> wrote: > On 11/11/13, Arun Khan <knura9 at gmail.com> wrote: >> On Mon, Nov 11, 2013 at 3:14 PM, hadi motamedi <motamedi24 at gmail.com> >> wrote: >>> Dear All >>> I needed to clone my disk to another hard drive . I did it as the >>> following : >>> #dd if=/dev/sdb of=/dev/sdc >>> But after a while, the procedure ended with the "writing to /dev/sdc >>> input/output error" message. >> >> Is /dev/sdc >= /dev/sdb? >> >> Also, input/output error is an indication of a hardware problem (disk >> controller on the board, cable, or the disk). >> >>> Can you please let me know how can I overcome this as the fdisk now >>> returns as " >>> #fdisk /dev/sdc >>> "I do not know how to handle files with mode 81a4 >>> must set cylinders" >> >> What does 'parted --list' display? >> >>> What can I do at know ? >> >> Post the answers for above. >> >> -- Arun Khan >> _______________________________________________ >> CentOS mailing list >> CentOS at centos.org >> http://lists.centos.org/mailman/listinfo/centos >> > > Please find below : > #parted -list > disk /dev/hda 21.5GB > sector : 512B/512B > partition : msdos > disk : /dev/sdb 40GB > sector : 512B/512B > partition : msdos > error: unable to open /dev/md0 > unrecognized disk label. Where is /dev/sdc? > _______________________________________________ > CentOS mailing list > CentOS at centos.org > http://lists.centos.org/mailman/listinfo/centos