2014/1/22 Jason T. Slack-Moehrle <slackmoehrle at gmail.com> > I am having an issue where eth1 is throwing some messages and stops > responding. Restarting networking doesn't work and also just bringing down > eth1 with 'ifdown' doesn't fix it. I have never seen anything like these > messages: > > eth1: no IPv6 routers present > r8169 0000:03:00.0: eth1: rtl_counters_cond == 1 (loop: 1000, delay: 10). > r8169 0000:03:00.0: eth1: rtl_chipcmd_cond == 1 (loop: 100, delay: 100). > r8169 0000:03:00.0: eth1: rtl_phyar_cond == 1 (loop: 20, delay: 25). > r8169 0000:03:00.0: eth1: rtl_phyar_cond == 1 (loop: 20, delay: 25). > r8169 0000:03:00.0: eth1: rtl_phyar_cond == 1 (loop: 20, delay: 25). > r8169 0000:03:00.0: eth1: rtl_phyar_cond == 1 (loop: 20, delay: 25). > r8169 0000:03:00.0: eth1: rtl_phyar_cond == 1 (loop: 20, delay: 25). > r8169 0000:03:00.0: eth1: rtl_phyar_cond == 1 (loop: 20, delay: 25). > r8169 0000:03:00.0: eth1: rtl_phy_reset_cond == 1 (loop: 100, delay: 1). > r8169 0000:03:00.0: eth1: rtl_phyar_cond == 1 (loop: 20, delay: 25). > r8169 0000:03:00.0: eth1: rtl_phyar_cond == 1 (loop: 20, delay: 25). > r8169 0000:03:00.0: eth1: rtl_phyar_cond == 1 (loop: 20, delay: 25). > r8169 0000:03:00.0: eth1: rtl_phyar_cond == 1 (loop: 20, delay: 25). > r8169 0000:03:00.0: eth1: rtl_phyar_cond == 1 (loop: 20, delay: 25). > r8169 0000:03:00.0: eth1: rtl_phyar_cond == 1 (loop: 20, delay: 25). > r8169 0000:03:00.0: eth1: rtl_phyar_cond == 1 (loop: 20, delay: 25). > r8169 0000:03:00.0: eth1: link up > Sound like broken network card? -- Eero