[CentOS] Booting Software RAID

Mon Jan 27 16:06:27 UTC 2014
Ljubomir Ljubojevic <centos at plnet.rs>

On 01/27/2014 04:26 PM, Matt wrote:
>> I installed Centos 6.x 64 bit with the minimal ISO and used two disks
>> in RAID 1 array.
>>
>> Filesystem      Size  Used Avail Use% Mounted on
>> /dev/md2         97G  918M   91G   1% /
>> tmpfs            16G     0   16G   0% /dev/shm
>> /dev/md1        485M   54M  407M  12% /boot
>> /dev/md3        3.4T  198M  3.2T   1% /vz
>>
>> Personalities : [raid1]
>> md1 : active raid1 sda1[0] sdb1[1]
>>        511936 blocks super 1.0 [2/2] [UU]
>> md3 : active raid1 sda4[0] sdb4[1]
>>        3672901440 blocks super 1.1 [2/2] [UU]
>>        bitmap: 0/28 pages [0KB], 65536KB chunk
>> md2 : active raid1 sdb3[1] sda3[0]
>>        102334336 blocks super 1.1 [2/2] [UU]
>>        bitmap: 0/1 pages [0KB], 65536KB chunk
>> md0 : active raid1 sdb2[1] sda2[0]
>>        131006336 blocks super 1.1 [2/2] [UU]
>>
>> My question is if sda one fails will it still boot on sdb?  Did the
>> install process write the boot sector on both disks or just sda?  How
>> do I check and if its not on sdb how do I copy it there?
>
> Based on input from everyone here I am thinking of an alternate setup.
>   Single small inexpensive 64GB SSD used as /boot, / and swap.  Putting
> /vz on software RAID1 array on the two 4TB drives.  I can likely just
> zip tie the SSD in the 1u case somewhere since I have no more drive
> bays.  Does this seem like a better layout?

As long as you have duplicate SSD as backup and regularly backup /boot 
to that other SSD, it should be OK. Loosing SSD and /boot with new 
kernels would be a mayor problem for you, you would need to recreate them.


Ljubomir Ljubojevic
(Love is in the Air)
PL Computers
Serbia, Europe

Google is the Mother, Google is the Father, and traceroute is your
trusty Spiderman...
StarOS, Mikrotik and CentOS/RHEL/Linux consultant