On 07/09/2014 10:50 AM, Mike McCarthy, W1NR wrote: > -----BEGIN PGP SIGNED MESSAGE----- > Hash: SHA1 > > This was a "minimal" install for a virtual server and semanage is not > available so the command doesn't work... > > What package is semanage in? Had to dig back in my notes: policycoreutils-python > > Mike > > On 07/09/2014 10:45 AM, Jonathan Billings wrote: >> On Wed, Jul 09, 2014 at 10:35:12AM -0400, Mike McCarthy, W1NR wrote: >>> I am having a problem getting sshd to run after changing it's default >>> port. I edit sshd_config and set the desired port, open it with >>> firewall-cmd and then issue a systemctl start sshd. No error gets >>> reported on the console but the following is logged in /var/messages >>> >>> sshd.service: main process exited, code=exited, status=255/n/a >>> >>> Not a very helpful error message. Sounds like I should report a bug? >> If you have SELinux enabled, it will block sshd from listening on a >> port other than what is described in the policy. You can add the >> additional port by running: >> >> semanage port -a -t ssh_port_t -p tcp $PORTNUM >> >> (replace $PORTNUM with the new port number you chose) >> > -----BEGIN PGP SIGNATURE----- > Version: GnuPG v2.0.22 (GNU/Linux) > Comment: Using GnuPG with Thunderbird - http://www.enigmail.net/ > > iEYEARECAAYFAlO9VsEACgkQW1M1BMdnYxmY1wCeNU+Jzf3bdoglIox15IxEuBF1 > d/gAoMYocoFEh73K5l2VeBhhsg/vsUdu > =5Sio > -----END PGP SIGNATURE----- > > _______________________________________________ > CentOS mailing list > CentOS at centos.org > http://lists.centos.org/mailman/listinfo/centos >