> -----Original Message----- > From: Eero Volotinen > Sent: Sunday, June 08, 2014 11:57 > > my bad dropping '0'. > > > > would tend to believe driver would be in later 6.x. then again. ;=) > > > > much luck. > > > > > Well, old system is running 5.10 and I need just transfer > data. noticed > some years ago that there can be different ext3 versions and if fs is > created with too new system, it cannot work with centos 5 or rhel 5 .. Assuming anaconda has your nic driver... If it is just transfer you need boot in to recovery with the install disc. Then do your magic from the command line. > > -- > Eero > _______________________________________________ > CentOS mailing list > CentOS at centos.org > http://lists.centos.org/mailman/listinfo/centos > > -- -=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=- - - - Jason Pyeron PD Inc. http://www.pdinc.us - - Principal Consultant 10 West 24th Street #100 - - +1 (443) 269-1555 x333 Baltimore, Maryland 21218 - - - -=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=- This message is copyright PD Inc, subject to license 20080407P00.