On Sun, Mar 23, 2014 at 1:39 PM, Nux! <nux at li.nux.ro> wrote: > On 22.03.2014 17:46, Ljubomir Ljubojevic wrote: > > I have RHEL 7 Beta installed in dual boot with CentOS 6.x. Since RHEL > > 7 > > installed GRUB2, I had problem that RHEL 7 is default boot. > > > > > > My personal solution was to go to /etc/grub.d and run command: > > mv 10_linux 31_linux > > > > grub2-mkconfig -o /boot/grub2/grub.cfg > > > > Explanation: > > > > > > - /etc/grub.d is where grub2 writes down config files used to create > > boot menu. > > - OS-prober creates 30_os-prober file in /etc/grub.d > > - 10_linux is created for RHEL/CentOS 7.x system installed. > > > > If you change order of files in /etc/grub.d (numbers at the start of > > the > > files) the list generated with grub2-mkconfig will change order in the > > GRUB2 menu :) > > Oh boy, I'm so going to miss Grub 0.97.. > Thanks for sharing, though! > That method of ordering configuration files has been around for decades, so nothing new there. (eg /etc/init.d). However I do find grub2's configuration a little confusing. Nothing new there. It'll sink in sometime, no doubt. Cheers, Cliff