On 02/26/2014 03:01 PM, Kenny Noe wrote: > Hello, I'm a newbie so here's my question. > > I'm trying to install CentOS 6.5 on a HP Proliant 350e server. This server > has 4x 1TB hard drives. I'd like to enable the hardware RAID 5 and stripe > all 4 disk into one 3TB logical volume. Then install CentOS on the 3TB > volume. However after I install I can't get the server to boot. How far does it get on the process? I set up an HP DL180 g5 server this week, and had it refuse to boot because I had not designated the boot volume when I set up the RAID. Once I went in and designated the boot volume, everything worked fine. If you are getting GRUB, but it doesn't get all the way through to booted, there are a lot of different places to get messed up along the way. Tell us more, and we can focus on where the your particular issue is. Ted Miller Elkhart, IN, USA > > I know about the MDOS vs GPT labeling issue. I've successfully installed > on one (singular) 3TB disk on other servers. I have modified the partition > tables, relabeling them to GPT, prior to completing the installs. > > However I've read that the Anaconda installer still tries to format as MDOS > and after installing a Basic server I cannot get it to boot. > > So, what am I missing? Can I load CentOS on a hardware RAID 5 volume that > is 3TB (usable) or am I stuck with what most Google searches say and load > the OS on one disk and then after use software RAID to RAID 5 the remaining > 3 disk into a /data directory? > > All help is appreciated. > > Thanks --Kenny > _______________________________________________ > CentOS mailing list > CentOS at centos.org > http://lists.centos.org/mailman/listinfo/centos >