[CentOS] CentOS 5.x and HP ACU CLI

Wed Mar 12 21:12:00 UTC 2014
John R Pierce <pierce at hogranch.com>

I had to install C5 on a dev server for various reasons (legacy system 
support and so forth).    This dev server is a HP DL180 G6, with a 
SmartArray P410 raid card...   I've installed hpacucli via the RPM from 
HP's site, but its not finding the controller...  C5 (64 bit) is using 
the default CCISS drivers for this card.

# hpacucli ctrl all show config

Error: No controllers detected.

lspci -v   reports...

06:00.0 RAID bus controller: Hewlett-Packard Company Smart Array G6 
controllers (rev 01)
         Subsystem: Hewlett-Packard Company Smart Array P410
         Flags: bus master, fast devsel, latency 0, IRQ 66
         Memory at fbc00000 (64-bit, non-prefetchable) [size=2M]
         Memory at fbbff000 (64-bit, non-prefetchable) [size=4K]
         I/O ports at d800 [size=256]
         Expansion ROM at fbb00000 [disabled] [size=512K]
         Capabilities: [40] Power Management version 3
         Capabilities: [50] MSI: Enable- Count=1/1 Maskable- 64bit+
         Capabilities: [70] Express Endpoint, MSI 00
         Capabilities: [ac] MSI-X: Enable+ Count=16 Masked-
         Capabilities: [100] Advanced Error Reporting
         Kernel driver in use: cciss
         Kernel modules: cciss

john r pierce                                      37N 122W
somewhere on the middle of the left coast