On Tue, Nov 11, 2014 at 5:08 PM, Chris Beattie <cbeattie at geninfo.com> wrote: > On 11/11/2014 2:27 PM, Steve Clark wrote: >> Buy second NIC and then the original script Jack Baily provided would work. > > I'm outside my area of expertise here, but is there a reason you couldn't fake a second network card by assigning two IP addresses to the one interface? > > I recall that the OP had two routers on opposite ends of the same subnet. If each router used its own subnet and everything was connected by a hub instead of a switch, then wouldn't the server know which way the packets needed to go out? Or a switch that knows VLANs, but that might be needlessly complex. > > I realize that means installing a hub instead of a second network card, so I'm just asking for my own edification. > There's no difference between a hub and switch with respect to routing. It might be possible to do something with a 2nd ip address in the same subnet used as the target of the port-forwarding from the other router along with policy based routing to make packets with that source ip take the other route. But that would introduce complications for normal outbound traffic. It may depend on the point of having the 2nd connection. Normally cable is so much faster than dls that you would always prefer it unless it was down. If the dsl is just for emergency inbound use you might run a VM configured with the other gateway as the default - maybe even set up openvpn there for fairly transparent access to the rest of the LAN. -- Les Mikesell lesmikesell at gmail.com