On 8/6/2015 4:21 PM, Chris Murphy wrote: > On Thu, Aug 6, 2015 at 2:08 PM, Bowie Bailey <Bowie_Bailey at buc.com> wrote: > >> Doing a new install on the two 1TB drives is my current plan. If that >> works, I can connect the old drive, copy over all the data, and then try to >> figure out what I need to do to get all the programs running again. > Sounds like a pain. I would just adapt the CentOS 6 program.log > commands for your case. That's a 2 minute test. And it ought to work. I'm not familiar with that. How would I go about adapting the CentOS 6 program.log commands? > Clearly the computer finds the drive, reads the MBR and executes stage > 1. The missing part is it's not loading or not executing stage 2 for > some reason. I'm just not convinced the bootloader is installed > correctly is the source of the problem with the 2nd drive. It's not > like the BIOS or HBA card firmware is going to faceplace right in > between stage 1 and stage 2 bootloaders executing. If there were a > problem there, the drive simply doesn't show up and no part of the > bootloader gets loaded. Definitely a strange problem. I'm hoping that doing a new install onto these drives rather than trying to inherit the install used on the smaller drives will work better. -- Bowie