Am 06.08.2015 um 22:21 schrieb Chris Murphy <lists at colorremedies.com>: > On Thu, Aug 6, 2015 at 2:08 PM, Bowie Bailey <Bowie_Bailey at buc.com> wrote: > >> Doing a new install on the two 1TB drives is my current plan. If that >> works, I can connect the old drive, copy over all the data, and then try to >> figure out what I need to do to get all the programs running again. > > Sounds like a pain. I would just adapt the CentOS 6 program.log > commands for your case. That's a 2 minute test. And it ought to work. > > Clearly the computer finds the drive, reads the MBR and executes stage > 1. The missing part is it's not loading or not executing stage 2 for > some reason. I'm just not convinced the bootloader is installed > correctly is the source of the problem with the 2nd drive. It's not > like the BIOS or HBA card firmware is going to faceplace right in > between stage 1 and stage 2 bootloaders executing. If there were a > problem there, the drive simply doesn't show up and no part of the > bootloader gets loaded. on which OS (eg. c5, c6) was the partition created? -- LF