On 8/6/2015 4:55 PM, Leon Fauster wrote: > Am 06.08.2015 um 22:39 schrieb Leon Fauster <leonfauster at googlemail.com>: >> Am 06.08.2015 um 22:21 schrieb Chris Murphy <lists at colorremedies.com>: >>> On Thu, Aug 6, 2015 at 2:08 PM, Bowie Bailey <Bowie_Bailey at buc.com> wrote: >>> >>>> Doing a new install on the two 1TB drives is my current plan. If that >>>> works, I can connect the old drive, copy over all the data, and then try to >>>> figure out what I need to do to get all the programs running again. >>> Sounds like a pain. I would just adapt the CentOS 6 program.log >>> commands for your case. That's a 2 minute test. And it ought to work. >>> >>> Clearly the computer finds the drive, reads the MBR and executes stage >>> 1. The missing part is it's not loading or not executing stage 2 for >>> some reason. I'm just not convinced the bootloader is installed >>> correctly is the source of the problem with the 2nd drive. It's not >>> like the BIOS or HBA card firmware is going to faceplace right in >>> between stage 1 and stage 2 bootloaders executing. If there were a >>> problem there, the drive simply doesn't show up and no part of the >>> bootloader gets loaded. >> >> on which OS (eg. c5, c6) was the partition created? > s/partition/filesystem/ This is CentOS 5. -- Bowie