Unfortunately, hardware isn't always purchased at the same time and, even if it is, how do you know that the vendor didn't make some "transparent" change in production that isn't noticeable until you get into the details. Vendors ***shouldn't*** do that but then there's reality. ----- Original Message ----- From: "John R Pierce" <pierce at hogranch.com> To: centos at centos.org Sent: Thursday, December 10, 2015 5:10:23 PM Subject: Re: [CentOS] wifi on servers and fedora [was Re: 7.2 kernel panic on boot] On 12/10/2015 3:05 PM, Leroy Tennison wrote: > You think this is irritating, what about when you're trying to replicate the network configuration to failover hardware... IMHO, active/standby failover hardware should have exact identical configurations down to firmware revisions, so I'm not sure what the issue is. -- john r pierce, recycling bits in santa cruz _______________________________________________ CentOS mailing list CentOS at centos.org https://lists.centos.org/mailman/listinfo/centos Confidentiality Notice | This email and any included attachments may be privileged, confidential and/or otherwise protected from disclosure. Access to this email by anyone other than the intended recipient is unauthorized. If you believe you have received this email in error, please contact the sender immediately and delete all copies. If you are not the intended recipient, you are notified that disclosing, copying, distributing or taking any action in reliance on the contents of this information is strictly prohibited.