[CentOS] Problems with Samba-based Home-Directory
Meikel
meikel at fn.de
Tue Jul 7 05:00:04 UTC 2015
Am 05.07.2015 um 20:52 schrieb Gordon Messmer:
> On 07/05/2015 07:57 AM, Meikel wrote:
>> Jul 5 16:36:08 meikel-pc kernel: ADDRCONF(NETDEV_UP): eth0: link is not
>> ready
>> Jul 5 16:36:23 meikel-pc kernel: ADDRCONF(NETDEV_CHANGE): eth0: link
>> becomes ready
>>
>> It takes 15 seconds between the two messages until it becomes ready. I
>> have no idea why it first says that the link is not ready.
>
> It's probably autonegotiation of link speed. I'm not sure why it'd
> take that long. I'd think the most likely explanation would be a bad
> cable. Could also be a flaky port on the switch, or a flaky Ethernet
> card. What brand is the local interface?
> _______________________________________________
> CentOS mailing list
> CentOS at centos.org
> http://lists.centos.org/mailman/listinfo/centos
>
>
I'll check the cable (not clear how I can do that, probably using
another cable and connecting to another outlet).
I think the local interface is directly integrated into the Intel
Desktop Board DH87RL.
dmesg | grep eth
e1000e 0000:00:19.0: eth0: registered PHC clock
e1000e 0000:00:19.0: eth0: (PCI Express:2.5GT/s:Width x1) 00:22:4d:b0:e0:e1
e1000e 0000:00:19.0: eth0: Intel(R) PRO/1000 Network Connection
e1000e 0000:00:19.0: eth0: MAC: 11, PHY: 12, PBA No: FFFFFF-0FF
ADDRCONF(NETDEV_UP): eth0: link is not ready
e1000e: eth0 NIC Link is Up 100 Mbps Full Duplex, Flow Control: None
e1000e 0000:00:19.0: eth0: 10/100 speed: disabling TSO
ADDRCONF(NETDEV_CHANGE): eth0: link becomes ready
eth0: no IPv6 routers present
lspci | grep Ether
00:19.0 Ethernet controller: Intel Corporation Ethernet Connection
I217-V (rev 04)
It says that it has a speed of 10/100, but I definitely expect 1000 Mbps!
More information about the CentOS
mailing list