Ok, Patrick, i will see the web site. Thanks a lot, M. > On Jul 18, 2015, at 13:50, Patrick Hess <patrickhess at gmx.net> wrote: > > (Please don't top-post.) > > Milton Plasencia wrote: >> I copy the /etc/systemd/system/vncserver@:1.service to /etc/systemd/system/vncserver@:0.service > > As I said in my previous post, for what you are wanting to do, > vncserver is not the right tool. Use x11vnc instead (and also > remove the above copy). > >> Jul 18 11:17:16 systemd[1]: vncserver@:0.service: control process exited, code=exited status=98 >> Jul 18 11:17:16 systemd[1]: Failed to start Remote desktop service (VNC). >> Jul 18 11:17:16 systemd[1]: Unit vncserver@:0.service entered failed state. > > This error is caused by display :0 alreading being in use > by the X server. Again, in your case you don't want to run > vncserver anyway. > >> The problem is i not understand the “logic" of vnc connection, so i try to dark… > > If both your VNC server and client are on the same local network, > the following two commands should be all you need to get started: > > 1. On the server, from within the X session you want to share: > > x11vnc -forever -shared > > 2. Then, on the client: > > vncviewer your-vnc-server:0 > > You should also take a look at http://www.karlrunge.com/x11vnc/. > That site provides a ton of useful information on how to run > x11vnc in all different kinds of situations. > > Patrick > _______________________________________________ > CentOS mailing list > CentOS at centos.org > http://lists.centos.org/mailman/listinfo/centos