To set selinux to permissive or disabled mode during a kickstart installation, add the sed -i -e 's/\(^SELINUX=\).*$/\1permissive/' /etc/selinux/config command to the %post section of the kickstart file. Making sure to replace "permissive" with the required selinux mode. -- https://bugzilla.redhat.com/show_bug.cgi?id=435300 On 26 May 2015 at 04:40, Rob Kampen <rkampen at kampensonline.com> wrote: > On 05/26/2015 08:32 AM, Charlie Brune wrote: > >> Has the "selinux --disabled" line for kickstart files been depreciated? >> >> My CentOS 6.6 kickstart file contains the line: >> >> >> selinux --disabled >> >> After the install completes, SELinux is enabled instead of disabled. >> >> I believe this has been the default since at least 6.1 - the version I > installed on my workstation about three years ago. > It came up at first reboot with selinux enforcing. > Unlike CentOS 5.x where I used selinux in permissive mode only, I have > found 6.x seems to work just fine with enforcing mode provided one sets and > uses the appropriate selinux booleans that are in place for the packages > and work scenario that one needs. As far as I recall, I have only had one > or two situations where I've had to follow the the audittoallow > instructions. > > /etc/selinux/config contains "SELINUX=enforcing" instead of >> "SELINUX=disabled". >> >> Thanks, >> >> Charlie >> >> _______________________________________________ >> CentOS mailing list >> CentOS at centos.org >> http://lists.centos.org/mailman/listinfo/centos >> > > _______________________________________________ > CentOS mailing list > CentOS at centos.org > http://lists.centos.org/mailman/listinfo/centos >