> Try > > ping6 -I eth1 2000:8000:12:6:192:168:11:8 Thanks for the response. I tried. However, It did not resolve.... # ping6 -I eth1 2000:8000:12:6:192:168:11:8 PING 2000:8000:12:6:192:168:11:8(2000:8000:12:6:192:168:11:8) from fe80::a00:27ff:fe03:5b8a eth1: 56 data bytes On 2015/11/13 2:22, Paul Heinlein wrote: > On Thu, 12 Nov 2015, 米山陽介 wrote: > >> Hello >> >> Because I did not send , and then retransmitted. >> >> I am using the CentOS5.7. >> In a state where the link down, I did a ping to the IPv4 and IPv6. >> IPv4 succeeds in ping. but, IPv6 is ping fails. >> Once confirmed by ifconfig, it did not have a Link-Local Address. >> At link down, Is the Link-Local Address not set? >> Leave the link down, Is there a way to avoid this? >> >> # ethtool eth1 >> Settings for eth1: >> ～ >> Link detected: no >> >> # ifconfig eth1 >> eth1 Link encap:Ethernet HWaddr 08:00:27:83:74:54 >> inet addr:192.168.11.8 Bcast:192.168.11.255 Mask:255.255.255.0 >> inet6 addr: 2000:8000:12:6:192:168:11:8/64 Scope:Global >> UP BROADCAST MULTICAST MTU:1500 Metric:1 >> RX packets:786 errors:0 dropped:0 overruns:0 frame:0 >> TX packets:289 errors:0 dropped:0 overruns:0 carrier:0 >> collisions:0 txqueuelen:1000 >> RX bytes:81093 (79.1 KiB) TX bytes:46507 (45.4 KiB) >> >> # ping 192.168.11.8 >> PING 192.168.11.8 (192.168.11.8) 56(84) bytes of data. >> 64 bytes from 192.168.11.8: icmp_seq=1 ttl=64 time=0.033 ms >> 64 bytes from 192.168.11.8: icmp_seq=2 ttl=64 time=0.019 ms >> ～ >> >> # ping6 2000:8000:12:6:192:168:11:8 >> PING 2000:8000:12:6:192:168:11:8(2000:8000:12:6:192:168:11:8) 56 data >> bytes > > Try > > ping6 -I eth1 2000:8000:12:6:192:168:11:8 > > > > _______________________________________________ > CentOS mailing list > CentOS at centos.org > https://lists.centos.org/mailman/listinfo/centos > -- ■□■□■□■□■□■□■□■□■□■□■□■ 株式会社デージーネット フロンティア開発部 米山 陽介 TEL: (052)709-7121 FAX: (052)709-7122 e-mail: komeyama at designet.co.jp URL: http://www.designet.co.jp ■□■□■□■□■□■□■□■□■□■□■□■