[CentOS] KVM Virtualization Network VLAN CentOS7

Wed Apr 6 14:09:45 UTC 2016
Francis Mendoza <francis at mytechrepublic.com>

On Wed, Apr 6, 2016 at 9:47 PM, James Hogarth <james.hogarth at gmail.com>
wrote:

> On 6 Apr 2016 2:35 p.m., "Francis Mendoza" <francis at mytechrepublic.com>
> wrote:
> >
> > Im configuring my KVM and in my network configuration I have 4 Network
> > lancard
> >
> > 2 nic = using teaming0 for management with access port configured in the
> > switch side
> >
> > 2 nic = using teaming1 for guest VM DATA ports. and in the switch is
> > configured for LACP with trunk allowing vlan 10,20,30,40,50
> >
> > and configured in the CentOS7 the vlan 10, vlan 20,30,40,50 im sure its
> > already working because I tried to use one vlan and ping was successful.
> >
> > my question is can I assigned directly the 'team1_vlan10, team1_vlan20..
> > and so on to directly use in my guest VM instead of bridging the network
> > config in the VM.xml file? I tried to google and found only about
> bridging
> > it first and could not find the direct connection in the DATA port
> Teaming1
> >
> > Thank you in advance
> >
>
> What you'll need to do is from your team interface create the tagged
> interfaces. Then create a bridge for each vlan and associate the tagged
> interface with the bridge.
>
> When the guest is connected to that bridge the traffic will then be tagged
> by the vmhost on the way out so you don't need any tagged configuration in
> the guest.
>
>

Thanks James I will try to configure the bridge in the vlan.