On 12/12/2016 07:29 AM, Gary Stainburn wrote: > On Monday 12 December 2016 12:15:10 David Both wrote: >> The lm_sensors package is required for the sensors module of glances to >> work. After installing lm_sensors, run sensors-detect. The sensors >> command will show the sensors detected and their current values. glances >> should then display the sensor readings. > Somewhere tucked in the back of my mind a memory is screaming no. Wasn't there > a problem with lm_sensors where we were all told to remove / not install it > because of serious problems with the package possibly even breaking things. > > Presumably that's no longer the case > _______________________________________________ > CentOS mailing list > CentOS at centos.org > https://lists.centos.org/mailman/listinfo/centos If there was such a problem it is very far in the past or it only shows up on hardware I don't have. I have never had any problems with the lm_sensors package breaking things and I have been using it for years. -- ********************************************************* David P. Both, RHCE Millennium Technology Consulting LLC Raleigh, NC, USA 919-389-8678 dboth at millennium-technology.com www.millennium-technology.com www.databook.bz - Home of the DataBook for Linux DataBook is a Registered Trademark of David Both ********************************************************* This communication may be unlawfully collected and stored by the National Security Agency (NSA) in secret. The parties to this email do not consent to the retrieving or storing of this communication and any related metadata, as well as printing, copying, re-transmitting, disseminating, or otherwise using it. If you believe you have received this communication in error, please delete it immediately.