On 2/17/2016 4:56 PM, Chris Adams wrote: > Once upon a time, Mustafa Mohammed<netechie at yahoo.com> said: >> >I am trying to setup a backup system using Bacula on CentOS 6.7 installed on eserver x345 but cannot find the drivers > I set one of those up many years ago, probably RHEL 3 timeframe. No > drivers are necessary for the library, although you will have to find a > differential SCSI card that is still supported to connect it (don't know > about that; I haven't touched parallel SCSI in ages, and the TL891 was > probably the last high-voltage differential device I used). ooof, if that thing is HVD, then plugging it into a regular SCSI card will likely blow up the card, and could fry the SCSI interface on the library too. however, this manual, http://h10032.www1.hp.com/ctg/Manual/c00626568.pdf suggests there's two versions, HVD and regular fast-wide SE scsi. quite a bit of cabling is required. -- john r pierce, recycling bits in santa cruz