[CentOS] HDD badblocks

Wed Jan 20 14:26:32 UTC 2016
Lamar Owen <lowen at pari.edu>

On 01/19/2016 06:29 PM, J Martin Rushton wrote:
> (Off topic) I also
> remember seeing engineers determine which memory chip was at fault and
> replacing the chip using a soldering iron.  Try that on a DIMM!

As long as the DIMM isn't populated with BGA packages it's about a 
ten-minute job with a hot air rework station, which will only cost you 
around $100 or so if you shop around (and if you have a relatively 
steady hand and either good eyes or a good magnifier). It's doable in a 
DIY way even with BGA, but takes longer and you need a reballing mask 
for that specific package to make it work right.  Any accurately 
controlled oven is good enough to do the reflow (and baking Xbox boards 
is essentially doing a reflow......)

Yeah, I prefer tubes and discretes and through-hole PCB's myself, but at 
this point I've acquired a hot air station and am getting up to speed on 
surface mount, and am finding that it's not really that hard, just 

This is not that different from getting up to speed with something 
really new and different, like systemd.  It just requires being willing 
to take a different approach to the problem.  BGA 
desoldering/resoldering requires a whole different way of looking at the 
soldering operation, that's all.