On Fri, March 25, 2016 10:45 am, m.roth at 5-cent.us wrote: > Valeri Galtsev wrote: >> >> On Fri, March 25, 2016 9:55 am, m.roth at 5-cent.us wrote: >>> I don't think I've seen this with CentOS 6 or 5, but I had to repair an >>> external RAID box this morning. The server, running CentOS 7, has an >>> LSI HBA card in it, and it's presented to the system as /dev/sdb. >>> I shut off the RAID controller, powered it off, >> >> You did unmount filesystem on the machine before that, right? > > Of course! >> >>> did the repair, then plugged everything back in (that includes the two >>> fiber cables and the ethernet), and brought the RAID back up. I even >>> used its web page to restart the controller (in the RAID box. >>> >>> I couldn't remount the drive until I rebooted the server. >> >> Before powering off/disconnecting RAID box, did you remove resembling >> SCSI >> device? this is done if my memory doesn't fail me by doing this: >> >> echo 1 > /sys/class/scsi_device/6:0:0:0/device/delete > > No - I've never done that. With hot-swap drive bays, the system sees it > going out, and says so, and then the drive goes away, or becomes > inactive... but when I shove one back in, it sees it, though it may make > it as /dev/sd[letter+1] (that is, if it had been /dev/sdb, it's now > /dev/sdc). Then we will need real expert to chime in on this... >> >> (replace "6:0:0:0" with your device's address). If you didn't remove the >> device before powering it off, I'm not surprised. If you did remove the >> device before powering it off, I'm puzzled ;-) > > As I said, I expected the scsi-rescan-bus to clear it up, but though it > saw it, nothing changed. Did you do scsi-rescan-bus after you disconnected the device, and then again after you connected it back? I'm just shooting in a dark, but the first one probably will remove the device that disappeared, and the second will add the device back. And it may do nothing about devices that exist on the bus, even though they disappeared temporarily, then re-appeared. I, simple person, knowing not all devices/scsi controllers support hot swap, would just remove the device as I said in previous post before disconnecting (an rescan scsi bus after connecting it back). Valeri > <snip> > mark > > _______________________________________________ > CentOS mailing list > CentOS at centos.org > https://lists.centos.org/mailman/listinfo/centos > ++++++++++++++++++++++++++++++++++++++++ Valeri Galtsev Sr System Administrator Department of Astronomy and Astrophysics Kavli Institute for Cosmological Physics University of Chicago Phone: 773-702-4247 ++++++++++++++++++++++++++++++++++++++++