On 2016-05-03 15:49, m.roth at 5-cent.us wrote: > On the wiki page for creating a mirrored root drive, at > <https://wiki.centos.org/HowTos/Install_On_Partitionable_RAID1>, it first > tells you, in the install, to chose manual partitioning, and to leave at > least 1M at the end of the drive.... and then it tells you to create the > RAID 1 using /dev/sda and /dev/sdb - the *whole* raw drives. > > mark, currently creating a RAID 1 using just the raw drives, no > partitions Hi Mark, The advice to subtract a certain amount from the drive size is still sound. I subtract ~ 1GB (~ US$0.20), here's why. A typical vendor disclaimer for drive capacity: "some of the listed capacity is used for formatting and other functions, and thus will not be available for data storage". "Other functions" includes dynamic things like an inventory of spare sectors to remap sectors that develop unrecoverable errors, replacing them from a pre-existing inventory of spares. After a failure, a new, replacement drive may be short of the capacity needed to mirror all the sectors of the surviving RAID pair. AFAIK the Linux RAID driver won't try to reason about the need to mirror the final few blocks in the element, it just refuses to create a mirror from a mismatched pair. Trimming some from the "actual" size when creating a brand new mirror gives you some room to finagle a replacement. Probably should mention that in the last few years (?) the position of the md superblock was repositioned from 128K from the logical last block of the drive to 8K to 12K from the end of the drive, see man 4 md. HTH, HAND, -- Charles Polisher