> -----Original Message----- > From: centos-bounces at centos.org [mailto:centos-bounces at centos.org] On > Behalf Of Richard > Sent: Friday, September 30, 2016 8:50 AM > To: CentOS mailing list > Subject: Re: [CentOS] Virtualization Networking > > > > > Date: Friday, September 30, 2016 07:14:59 -0400 > > From: TE Dukes <tdukes at palmettoshopper.com> > > >> From: Gordon Messmer > >> Sent: Friday, September 30, 2016 1:01 AM > >> > >> On 09/29/2016 07:54 PM, TE Dukes wrote: > >> > For whatever reason, the default NAT setup no longer works. > >> > >> Start over with a new install. Record each change you make, > >> carefully. > >> > >> > I got some kind > >> > of bridge network (mactap) setup that has access to the outside but > >> > I still can't connect locally. > >> > >> > >> As I noted, when using the macvtap, the host and guest can't > >> communicate unless you enable hairpin mode. > >> > > > > I read something about turning off and disabling NetworkManager. I > > haven't done this. > > > > I'm getting ready to throw in the towel. If I can't set this up to at > > least access the VM from the LAN, I can't test CentOS 7 and the > > software I want to run. It makes it very hard to setup and configure > > with vi. > > > > I found this guide from Dell to be easy to follow in getting things set up > quickly. Once you have it working you can tweak things, but this might help > you get past your initial hurdles. > > > KVM Virtualization in RHEL 6 Made Easy > > <https://linux.dell.com/files/whitepapers/KVM_Virtualization_in_RHEL_6_ > made_easy.pdf> > Thanks!! I appreciate the help!!