[CentOS] Virtualization Networking
tdukes at palmettoshopper.com
Fri Sep 30 11:14:59 UTC 2016
> -----Original Message-----
> From: centos-bounces at centos.org [mailto:centos-bounces at centos.org] On
> Behalf Of Gordon Messmer
> Sent: Friday, September 30, 2016 1:01 AM
> To: CentOS mailing list
> Subject: Re: [CentOS] Virtualization Networking
> On 09/29/2016 07:54 PM, TE Dukes wrote:
> > For whatever reason, the default NAT setup no longer works.
> Start over with a new install. Record each change you make, carefully.
> > I got some kind
> > of bridge network (mactap) setup that has access to the outside but I
> > still can't connect locally.
> As I noted, when using the macvtap, the host and guest can't communicate
> unless you enable hairpin mode.
I read something about turning off and disabling NetworkManager. I haven't
I'm getting ready to throw in the towel. If I can't set this up to at least
access the VM from the LAN, I can't test CentOS 7 and the software I want to
run. It makes it very hard to setup and configure with vi.
More information about the CentOS