Apologies for the noise, it was a mistake from our side For some reason someone had set the installation directory to be from aarch64 instead of x86_64 On 22/08/2017 17:54, Arif Ali wrote: > Hi all, > > We have a customer, where we are trying to install CentOS 7.3 on the > new Intel Knights Landing nodes, unfortunately, we are unable to > install then using PXE boot. > > Now, I have a lot of experience of installation of machines using PXE > boot, so the setup of that is not the problem. Both myself and my > colleagues have looked through the problem, and we are unable to get > much diagnosis of the problem. > > When booting the machine via the network, it loads the ramdisk, and > then we get no output, and then the machine reboots. Unfortunately, we > have unable to get anything else on the screen. The machines don't > have VGA, and monitor capable ports, so we are stuck with Serial Over > Lan over IPMI. > > We have however, after some searching via search engines, we found > some documentation suggesting that RHEL 7.2 and then with significant > updates on 7.3 do work on these types of machines. We have then > followed the same process to try installing the machines, and we have > managed to get the machine up, and in a working order. However, we'd > like to use CentOS 7.3, and would like to find the process of doing > so, if it is any different > > I was wondering to see if anyone else has seen any similar issues, and > if there is a problem here, that we haven't tackled? Any further > debugging we can do? Any assistance on this would be much appreciated > -- regards, Arif Ali