On 11/01/2017 03:06 PM, Gordon Messmer wrote: > On 11/01/2017 07:55 AM, Scott Gennari wrote: >> /etc/xen/scripts/network-bridge-pcl >> >> #/bin/sh >> >> dir=$(dirname "$0") >> "$dir/network-bridge" "$@" vifnum=1 netdev=eth2 bridge=xen-dmz2 >> "$dir/network-bridge" "$@" vifnum=3 netdev=eth0 bridge=xen-dmz1 > > > Do you get any error output when you run: > > /etc/xen/scripts/network-bridge vifnum=1 netdev=eth2 bridge=xen-dmz2 > > If not, try: > > bash -x /etc/xen/scripts/network-bridge vifnum=1 netdev=eth2 > bridge=xen-dmz2 > > And if all else fails, set up a bridged interface by hand: > > brctl addbr xen-dmz2 > ip link set dev eth2 up > brctl addif xen-dmz2 eth2 > > -- Hi Gordon, Thanks for this, I was able to get xen-dmz1 & 2 setup using the manual method you described and get the domain/guests back online. Much appreciated, Scott