On February 22, 2018 3:46:25 AM EST, Nux! <nux at li.nux.ro> wrote: >Install the excellent openconnect client from EPEL, I think there is >also a NetworkManager plugin for it so you can use a UI, though the cli >is not too bad. > >-- >Sent from the Delta quadrant using Borg technology! > >Nux! >www.nux.ro > >----- Original Message ----- >> From: "H" <agents at meddatainc.com> >> To: "CentOS mailing list" <centos at centos.org> >> Sent: Thursday, 22 February, 2018 02:35:33 >> Subject: [CentOS] Cisco AnyConnect Mobility Client for 32- bit CentOS >6 > >> I have the above installed on a couple of 64-bit systems, both CentOS >6 and >> CentOS 7, where the client works fine. >> >> Now, however, I have installed the 32-bit version of CentOS 6 on a >netbook but I >> cannot get the Cisco website installer to recognize the >computer/operating >> system, not even displaying any error message. >> >> Does anyone have the client running on a 32-bit system? I have been >told it >> should run on a 32-bit system and did have it running on the same >netbook while >> it was still running Vista Home edition, another 32-bit operating >system. >> >> _______________________________________________ >> CentOS mailing list >> CentOS at centos.org >> https://lists.centos.org/mailman/listinfo/centos >_______________________________________________ >CentOS mailing list >CentOS at centos.org >https://lists.centos.org/mailman/listinfo/centos Thank you, the client works nicely! It needs to be run as root and then a regular user gets the benefit of the VPN connection.