On 21 June 2018 12:13:02 "anax" <anax at ayni.com> wrote: > Hi Shagun > check your settings of PEERDNS and IPV6_PEERDNS... > > suomi > > On 06/21/2018 08:33 AM, Maheshwari, Shagun wrote: >> Hi, >> >> I am facing issue stoping NetworkManager to update resolv.cfg, I am using >> below configuration for eth0 interface: >> >> TYPE=Ethernet >> BOOTPROTO=dhcp >> DEFROUTE=yes >> IPV4_FAILURE_FATAL=no >> IPV6INIT=yes >> IPV6_AUTOCONF=yes >> IPV6_DEFROUTE=yes >> IPV6_FAILURE_FATAL=no >> IPV6_ADDR_GEN_MODE=stable-privacy >> NAME=eth0 >> UUID=93b90a46-dab5-4a67-8fd0-fefe8874a8b9 >> DEVICE=eth0 >> ONBOOT=no >> PEERDNS=no >> PEERROUTES=yes >> IPV6_PEERDNS=yes >> IPV6_PEERROUTES=yes >> DNS1=<ipv4 address> >> DNS2=<ipv6 address> >> >> >> Also, added dns=none in NetworkManager.conf file. >> >> Whenever I am restarting NetworkManager, resolv.cfg gets updated and only >> ipv4 nameserver is displaced, whether I am expecting both the ips (ipv6 and >> ipv4 address to be present in resolv.cfg file. >> >> Any suggestion here, how to achieve that?? >> >> Regards, >> Shagun >> _______________________________________________ >> CentOS mailing list >> CentOS at centos.org >> https://lists.centos.org/mailman/listinfo/centos >> > _______________________________________________ > CentOS mailing list > CentOS at centos.org > https://lists.centos.org/mailman/listinfo/centos I think this was a bug in 7.2 have you updated your rpms. Peerdns ignored. Regards peter Sent with AquaMail for Android https://www.mobisystems.com/aqua-mail