> > >From: CentOS <centos-bounces at centos.org> on behalf of Phil Perry <pperry at elrepo.org> >Sent: Monday, December 2, 2019 10:58 AM >To: centos at centos.org <centos at centos.org> >Subject: Re: [CentOS] Adding kmod to pxe install > >On 02/12/2019 16:08, Valeri Galtsev wrote: >> >> >> On 2019-12-02 10:00, Fabian Arrotin wrote: >>> On 02/12/2019 12:42, Alexandre Leonenko wrote: >>>> Hey guys, >>>> >>>> I'm stumped in how to add the kmod rpm to pxe install. I need it to >>>> be installed but also loaded during the install as well. >>>> The rpm in question is the 3w-9xxx from elrepo >>>> https://centos.pkgs.org/8/elrepo-x86_64/kmod-3w-9xxx-2.26.02.014-1.el8_0.elrepo.x86_64.rpm.html >>>> >>>> >>>> I'm constantly getting the following message >>>> Warning: can't find installer main image path in .treeinfo >>>> >>>> Any help or pointing in right direction would be appreciated. >>>> >>>> Regards, >>>> Alex >>> >>> If you need it at install time, you need a dud (Driver Disk), so see >>> http://mirrors.coreix.net/elrepo/dud/el8/x86_64/ and use inst.dd= >>> >> >> Thank you, Fabian! I too may need it in close future. >> >> Valeri >> > >Hopefully it's obvious, but make sure you pick the driver update disk >image that matches the kernel/point release you are installing (e.g, >el8_0 or el8_1 etc). > >_______________________________________________ >CentOS mailing list >CentOS at centos.org >https://lists.centos.org/mailman/listinfo/centos <https://lists.centos.org/mailman/listinfo/centos> Thanks a lot guys.