[CentOS] Adding kmod to pxe install

Alexandre Leonenko alex at esecuredata.com
Wed Dec 4 00:10:05 UTC 2019


>
>
>From: CentOS <centos-bounces at centos.org> on behalf of Phil Perry <pperry at elrepo.org>
>Sent: Monday, December 2, 2019 10:58 AM
>To: centos at centos.org <centos at centos.org>
>Subject: Re: [CentOS] Adding kmod to pxe install
>
>On 02/12/2019 16:08, Valeri Galtsev wrote:
>>
>>
>> On 2019-12-02 10:00, Fabian Arrotin wrote:
>>> On 02/12/2019 12:42, Alexandre Leonenko wrote:
>>>> Hey guys,
>>>>
>>>> I'm stumped in how to add the kmod rpm to pxe install. I need it to
>>>> be installed but also loaded during the install as well.
>>>> The rpm in question is the 3w-9xxx from elrepo
>>>> https://centos.pkgs.org/8/elrepo-x86_64/kmod-3w-9xxx-2.26.02.014-1.el8_0.elrepo.x86_64.rpm.html
>>>>
>>>>
>>>> I'm constantly getting the following message
>>>> Warning: can't find installer main image path in .treeinfo
>>>>
>>>> Any help or pointing in right direction would be appreciated.
>>>>
>>>> Regards,
>>>> Alex
>>>
>>> If you need it at install time, you need a dud (Driver Disk), so see
>>> http://mirrors.coreix.net/elrepo/dud/el8/x86_64/ and use inst.dd=
>>>
>>
>> Thank you, Fabian! I too may need it in close future.
>>
>> Valeri
>>
>
>Hopefully it's obvious, but make sure you pick the driver update disk
>image that matches the kernel/point release you are installing (e.g,
>el8_0 or el8_1 etc).
>
>_______________________________________________
>CentOS mailing list
>CentOS at centos.org
>https://lists.centos.org/mailman/listinfo/centos
<https://lists.centos.org/mailman/listinfo/centos>
Thanks a lot guys.


More information about the CentOS mailing list