[CentOS] how to activate the network after an installation
Harald Dunkel
harald.dunkel at aixigo.de
Mon Jan 21 14:47:14 UTC 2019
Hi Ralf,
On 1/21/19 11:39 AM, Ralf Prengel wrote:
>
> Hallo,
>
> I can t find the switch to activate the network after an installation without gui.
> service network start doesn t work and I don t find any other commands.
>
If the setuptool package is not installed, then I would suggest to
use ip or ifconfig to temporarily assign a network configuration.
Then use yum to install the setuptool package.
Use "setup" to configure network devices, directory services and
runtime services in your favorite terminal window.
Good luck
Harri
More information about the CentOS
mailing list