[CentOS] how to activate the network after an installation
Harald Dunkel
harald.dunkel at aixigo.deMon Jan 21 14:47:14 UTC 2019
- Previous message: [CentOS] how to activate the network after an installation
- Next message: [CentOS] Yum refuses to install kmod-8188eu from elrepo
- Messages sorted by: [ date ] [ thread ] [ subject ] [ author ]
Hi Ralf, On 1/21/19 11:39 AM, Ralf Prengel wrote: > > Hallo, > > I can t find the switch to activate the network after an installation without gui. > service network start doesn t work and I don t find any other commands. > If the setuptool package is not installed, then I would suggest to use ip or ifconfig to temporarily assign a network configuration. Then use yum to install the setuptool package. Use "setup" to configure network devices, directory services and runtime services in your favorite terminal window. Good luck Harri
- Previous message: [CentOS] how to activate the network after an installation
- Next message: [CentOS] Yum refuses to install kmod-8188eu from elrepo
- Messages sorted by: [ date ] [ thread ] [ subject ] [ author ]
More information about the CentOS mailing list