and I'm doing much the same: a Raspberry Pi running Raspbian, acts as my nameserver (instead of my ISP) and NTP server. all the systems in-house sync time from it. On Wed, Dec 2, 2020 at 3:22 PM Bill Gee <bgee at campercaver.net> wrote: > What IS in your chrony.conf file? > > "pool.ntp.org" is not a single server. It is a collection of several > dozen. When you specify a pool of servers for chrony, it will pick 4 > mostly at random and use those. The four servers it chooses will change > over time. > > If you want to use exactly one specific server, then take the pool out of > chrony.conf and add your specific server. I do not see a way for chronyc > to remove servers, so it is a matter of editing the file directly and then > restarting chronyd. > > In my case, only my internal master server goes against a pool. All other > internal systems use the internal master as their only source. Sometimes > when I do "chronyc sources" on them, I see the server listed twice. After > investigation I found that one is for IPv4 and the other for IPv6. > > -- > Bill Gee > > > > On Wednesday, December 2, 2020 2:00:56 PM CST Jerry Geis wrote: > > Thanks everyone for the comments. So trying to use the new "chronyc/d" > > > > So trying a couple things with chronyc > > > > chronyc sources > > 210 Number of sources = 5 > > MS Name/IP address Stratum Poll Reach LastRx Last sample > > > =============================================================================== > > ^* time.cloudflare.com 3 10 377 220 -481us[ -503us] +/- > > 17ms > > ^- zeit.arpnetworks.com 2 9 377 452 -1083us[-1104us] +/- > > 100ms > > ^- lofn.fancube.com 2 10 377 851 -1833us[-1854us] +/- > > 64ms > > ^- ntp3.junkemailfilter.com 2 9 377 227 -937us[ -959us] +/- > > 76ms > > ^- b.st1.ntp.br 1 6 377 56 -2300us[-2300us] +/- > > 79ms > > > > NONE of the above are listed in /etc/chrony.conf > > > > Then I tried "chronyc add server pool.ntp.porg" and ran "chronyc sources" > > again and my server was not added ? > > > > I am trying to use the command line chronyc - to "add" the server I want > - > > also wish there was an EASY way to clear the server list. Have not seen > > that though. > > > > What I need is a way to add the server i want - list the server to make > > sure my server is in the list - and remove servers I dont want (or all). > > > > Thanks, > > > > Jerry > > _______________________________________________ > > CentOS mailing list > > CentOS at centos.org > > https://lists.centos.org/mailman/listinfo/centos > > > > _______________________________________________ > CentOS mailing list > CentOS at centos.org > https://lists.centos.org/mailman/listinfo/centos >