[CentOS] Install Problems Centos 4.1
Peter Farrow
peter at farrows.org
Thu Jul 21 14:55:25 UTC 2005
"Don't know whether I understand you correctly, but RAID1 array sync is
started with firstboot after the installation finished."
Err....no it doesn't.... it syncs the array as it installs, do a cntrl-alt-f3 when installing to bring a shell up then do a "watch cat /proc/mdstat"
and you can see it building the array as its installing, do a cntrl-alt-f7 to get back to the graphics screen.....
I did actually find what the problem was and this was it:
The SIS 965 chipset is not supported by the kernel so the IDE interfaces runs S-L-O-W-L-Y eg 1.7Mb/sec transfer rate to the disk, coupled with the RAID rebuilding in the background makes the install take about 6 hours if it can actually manage to complete, which it usually doesn't on this platform.
The solution: change the motherboard.... so I put a sempron socket A board in its place with a 3200+ CPU and it works fine....
:-)
Alexander Dalloz wrote:
>Am Do, den 21.07.2005 schrieb Peter Farrow um 10:03:
>
>
>
>>I have a K8S-MX Asus Athlon 64 Motherboard with a 754 pin 3000+ CPU,
>>which I cam trying to install 4.1 Centos 64 bit.
>>
>>The problem seems to arise when installing onto Mirrored disks, I have
>>noticed that from Centos 4 onwards it tries to rebuild the arrays as it
>>installs which slows the whole process right down across all platforms I
>>have tried it on.
>>
>>
>
>Don't know whether I understand you correctly, but RAID1 array sync is
>started with firstboot after the installation finished.
>
>
>
>>In addition, the install process bails out at random times with random
>>errors eg. "Disk Full", "error loading this package or that package",
>>Error reading DVD etc... now I have burnt several copies of the DVD,
>>tested them fully, tried installing from CD, even changed the hardware
>>to a twin Opteron system, changed the RAM changed this disks and tried
>>everything but it still seems really touch and go as to wether the
>>install will complete.
>>
>>I haven't managed it yet on the Asus platform it took about 12 goes on
>>the opteron platform. Yet Centos 3.4 installs no problem.
>>
>>
>
>That can be caused by bad cabling (length + quality) because kernel 2.6
>is more sensible for standards. It can too help to deactivate DMA during
>install with: linux ide=nodma.
>
>
>
>>Finally the last straw was the boot loader problem with occurs either
>>immediately after reboot after install or on one of the boots soon
>>after, and I have to do this to fix it:
>>
>>
>
>That is a known issue and filed in bugzilla.redhat.com. Didn't happen
>for my platform, grub was correctly installed, just not placed into both
>RAID1 drive's MBRs.
>
>
>
>>Pete
>>
>>
>
>Alexander
>
>
>
>
>------------------------------------------------------------------------
>
>_______________________________________________
>CentOS mailing list
>CentOS at centos.org
>http://lists.centos.org/mailman/listinfo/centos
>
>
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.centos.org/pipermail/centos/attachments/20050721/fdc40e85/attachment.html>
More information about the CentOS
mailing list