[CentOS] Centos 4.4 Install bug

Peter Farrow peter at farrows.org
Sun Sep 17 21:18:47 UTC 2006


Rather than looking at an install bug [which is entirely feasible], I 
would look at the BIOS on the motherboard itself and see if there is a 
later version first...

P.


Seth Bardash wrote:
> To the Centos maintainers:
>
> We tried to install Centos 4.4 i386 (i686 / Athlon)
> on a Dual Opteron 254 Iwill DK8N MB, 1GB (4 x 256M)
> system with a 3ware 9500S-4 and 4 x 80 GB disks
> in a RAID 10 array.
>
> Both tries caused Centos to first kernel panic
> until we turned off IO-APIC in the BIOS.
>
> Both tries also only loaded the UP kernel
> and did not load the smp kernel on the machine.
>
> The smp kernel was not even installed on the machine. 
> The BIOS see 2 cpu's and so did 4.3. There seems to be a
> CPU qty discovery problem during install.
>
> When the smp kernel is installed from rpm it works
> fine and even enables numa properly.
>
> We used the Net boot i386 iso image and loaded
> the machine from over the network.
>
> We then tried the x86_64 version with the same 
> results.
>
> Any suggestions???
>
>
> Seth Bardash
>
> Integrated Solutions and Systems
> 1510 Old North Gate Road
> Colorado Springs, CO 80921
>
> 719-495-5866
> 719-495-5870 Fax
> 719-337-4779 Cell
>
> http://www.integratedsolutions.org
>
> Failure can not cope with knowledge and perseverance! 
>  
>
>   

-- 
This message has been scanned for viruses and
dangerous content by the Enhancion system Scanner
and is believed to be clean.
http://www.enhancion.net




More information about the CentOS mailing list