[CentOS] Installing CentOS 5.4 64bit on server with LSI SAS 1068E controller.

Tait Clarridge tait at clarridge.ca
Sat Nov 28 03:41:45 UTC 2009


On Fri, 2009-11-27 at 22:10 -0500, Billy Huddleston wrote:
> I just read the user manual on it.. It says the following...
> 
> IT Mode (Initiator and Target Mode)
> This is a Non-RAID mode. To use this mode, be sure to fl ash an IT
> mode firmware to the EEPROM and to install an IT Mode driver to the
> system OS. 
> 
> So, I'm confused, what point is a RAID controller that doesn't support
> RAID ? 
> 
> Thanks, Billy

Probably for compliance, might as well give it a try if you can... 

The Perc 4i/5i stuff that Steve was talking about is definitely
supported as I have a server that uses this. They may be exposed and use
different drivers than the straight LSI SAS 1068E.

Steve: What module does your Dell Perc use? I don't have access to my
server to check.

-------------- next part --------------
A non-text attachment was scrubbed...
Name: not available
Type: application/pgp-signature
Size: 198 bytes
Desc: This is a digitally signed message part
Url : http://lists.centos.org/pipermail/centos/attachments/20091127/4cc3dfec/attachment.bin 


More information about the CentOS mailing list