Pessoal, boa tarde

Estou usando bond em minha interfaces como active backup, em teoria, uma interface deveria assumir ( ou funcionar ) somente quando a outra interface ficar down.

Mas estou com perda de pacotes justamente na interface que não está sendo usada e está gerando perda de pacotes no bond.

What que pode ser ?

Segue minhas configurações de bond

[root@xxxxx ~]# ifconfig bond0 ; ifconfig eth0 ; ifconfig eth1 bond0 Link encap:Ethernet HWaddr 2C:59:E5:3C:71:68 inet addr:10.104.x.x Bcast:10.104.172.255 Mask:255.255.255.0 UP BROADCAST RUNNING MASTER MULTICAST MTU:1500 Metric:1 RX packets:38386574 errors:0 dropped:1295024 overruns:0 frame:0 TX packets:34733102 errors:0 dropped:0 overruns:0 carrier:0 collisions:0 txqueuelen:0 RX bytes:23626317629 (22.0 GiB) TX bytes:21028389425 (19.5 GiB)

eth0 Link encap:Ethernet HWaddr 2C:59:E5:3C:71:68 UP BROADCAST RUNNING SLAVE MULTICAST MTU:1500 Metric:1 RX packets:37091397 errors:0 dropped:0 overruns:0 frame:0 TX packets:34732869 errors:0 dropped:0 overruns:0 carrier:0 collisions:0 txqueuelen:1000 RX bytes:23524827730 (21.9 GiB) TX bytes:21028299937 (19.5 GiB)

eth1 Link encap:Ethernet HWaddr 2C:59:E5:3C:71:68 UP BROADCAST RUNNING SLAVE MULTICAST MTU:1500 Metric:1 RX packets:1295179 errors:0 dropped:1294944 overruns:0 frame:0 TX packets:237 errors:0 dropped:0 overruns:0 carrier:0 collisions:0 txqueuelen:1000 RX bytes:101490019 (96.7 MiB) TX bytes:90360 (88.2 KiB)

[root@xxxxx ~]#

[root@xxxxx ~]# cat /proc/net/bonding/bond0 Ethernet Channel Bonding Driver: v3.7.1 (April 27, 2011)

Bonding Mode: fault-tolerance (active-backup) Primary Slave: None Currently Active Slave: eth0 MII Status: up MII Polling Interval (ms): 1000 Up Delay (ms): 0 Down Delay (ms): 0

Slave Interface: eth0 MII Status: up Speed: 10000 Mbps Duplex: full Link Failure Count: 0 Permanent HW addr: 2c:59:e5:3c:71:68 Slave queue ID: 0

Slave Interface: eth1 MII Status: up Speed: 10000 Mbps Duplex: full Link Failure Count: 0 Permanent HW addr: 2c:59:e5:3c:71:6c Slave queue ID: 0

[root@xxxxx ~]# cat /etc/sysconfig/network-scripts/ifcfg-bond0 DEVICE=bond0 IPADDR=10.104.x.x NETMASK=255.255.255.0 ONBOOT=yes BOOTPROTO=none USERCTL=no BONDING_OPTS="mode=1 miimon=1000"

No /var/log/messages Tenho muitos logs de martian source ....

[root@xxxxx ~]# tail -f /var/log/messages Sep 17 13:26:38 xxxxx kernel: IPv4: martian source 10.104.172.0 from 0.0.0.0, on dev bond0 Sep 17 13:26:38 xxxxx kernel: ll header: 00000000: ff ff ff ff ff ff 00 00 00 00 5b 00 08 00 ..........[... Sep 17 13:26:39 xxxxx kernel: IPv4: martian source 10.104.172.0 from 0.0.0.0, on dev bond0 Sep 17 13:26:39 xxxxx kernel: ll header: 00000000: ff ff ff ff ff ff 00 00 00 00 5b 01 08 00 ..........[... Sep 17 13:26:39 xxxxx kernel: IPv4: martian source 10.104.172.0 from 0.0.0.0, on dev bond0 Sep 17 13:26:39 xxxxx kernel: ll header: 00000000: ff ff ff ff ff ff 00 00 00 00 5b 00 08 00 ..........[... Sep 17 13:26:39 xxxxx kernel: IPv4: martian source 10.104.172.0 from 0.0.0.0, on dev bond0 Sep 17 13:26:39 xxxxx kernel: ll header: 00000000: ff ff ff ff ff ff 00 00 00 00 5b 00 08 00 ..........[... Sep 17 13:26:39 xxxxx kernel: IPv4: martian source 10.104.172.0 from 0.0.0.0, on dev bond0 Sep 17 13:26:39 xxxxx kernel: ll header: 00000000: ff ff ff ff ff ff 00 00 00 00 5b 01 08 00 ..........[... Sep 17 13:26:43 xxxxx kernel: net_ratelimit: 69 callbacks suppressed