On Thu, Oct 10, 2019 at 9:04 AM Nux! nux@li.nux.ro wrote:
There was a recent thread about Redhat's removal of drivers from LSI SAS2, it's probably the problem you are facing. It can be worked around with the help of Elrepo repo.
https://lists.centos.org/pipermail/centos/2019-October/173682.html
https://elrepoproject.blogspot.com/2019/08/rhel-80-and-support-for-removed-a...
https://elrepo.org/linux/dud/el8/x86_64/dd-mpt3sas-27.101.00.00-1.el8_0.elre...
Is there a utility somewhere to check a running system to see if it is going to be supported in RHEL/CentOS 8?
Sent from the Delta quadrant using Borg technology!
On 2019-10-10 14:01, Brewer, Mitchell wrote:
I have an older Dell PowerEdge server with one hard drive, with CentOS 7 currently installed. I wanted to do a clean install of CentOS 8, but it doesn't pick up the hard drive. When I click on the destination to pick the hard drive it only shows the USB drive that I'm installing from. I checked for a RAID configuration on the server, but there is only one disk, and no RAID is configured. The disk is controlled by the PowerEdge Raid Controller (PERC), but when I disable that I lose the disk completely. I suspect that PERC is part of the problem, but a CentOS 7 install proceeds normally with PERC enabled. Do you know of a change from CentOS 7 to 8 that would cause this, or if there is a workaround? I've searched for several days and haven't found anything yet.
Thank you!
Mitch
Mitchell Brewer Research Systems Administrator Laboratory for Physical Sciences (LPS) (410)570-3516 (Mobile) (443)-654-7897 (Office) _______________________________________________ CentOS mailing list CentOS@centos.org https://lists.centos.org/mailman/listinfo/centos
CentOS mailing list CentOS@centos.org https://lists.centos.org/mailman/listinfo/centos