Matthew Martz wrote:

On Wed, November 22, 2006 1:42 pm, Matthew Martz wrote:

...

I'm in need of installing two NICs in a machine that are connected to 2 different public networks and I need both IP addresses accessible from the outside. The IPs are part of two completely different subnets.

For example: eth0 IP - 10.10.10.2/30 GW - 10.10.10.1

eth1 IP - 20.20.20.6/30 GW - 20.20.20.5

How can I configure 2 gateways on this server?

I should probably also mention that I want traffic that comes in over eth0 to go out over eth0 and traffic that comes in on eth1 to go out on eth1.

I pretty much have this same setup. I don't have routing enabled is all. I configure each ethx device like they were on a single network. When your system is up and running, check the routing table, using route. It'll tell you which interface can reach which networks. My setup has 192.168.a.b/24 on eth0, 192.168.c.d/24 on eth1 and I can ping hosts on both networks.

There's always a possibility I don't understand your question! :)

Thanks!

Mark Schoonover IS Manager American Geotechnical V: 858-450-4040 - F: 714-685-3909 - C: 858-472-3816

"Stop the Earth!! I want off!!"