I have a system that I just installed with CentOS 4.0. It is an HP NetServer E 60 with dual CPUs and 1G RAM. There is an Adaptec AIC-7895 built into the motherboard.

On bootup, I get this:

(scsi0:A:1): 11.626MB/s transfers (5.813MHz, offset 8, 16bit) (scsi0:A:1:0): data overrun detected in Data-in phase. Tag == 0x2. (scsi0:A:1:0): Have seen Data Phase. Length = 255. NumSGs = 1. sg[0] - Addr 0x03ace40 : Length 255 (scsi0:A:1:0): data overrun detected in Data-in phase. Tag == 0x3. (scsi0:A:1:0): Have seen Data Phase. Length = 255. NumSGs = 1. sg[0] - Addr 0x03ace40 : Length 255 (scsi0:A:1:0): data overrun detected in Data-in phase. Tag == 0x2. (scsi0:A:1:0): Have seen Data Phase. Length = 255. NumSGs = 1. sg[0] - Addr 0x03ace40 : Length 255 scsi scan: 255 byte inquiry failed with code 458752. Consider BLIST_INQUIRY_36 for this device Vendor: WDIGTL Model: WDE18300 ULTRA2 Rev: 1.30 Type: Direct-Access ANSI SCSI revision: 02 scsi0:A:1:0: Tagged Queuing enabled. Depth 4 SCSI device sdb: 35761710 512-byte hdwr sectors (18310 MB) SCSI device sdb: drive cache: write back sdb: sdb1 Attached scsi disk sdb at scsi0, channel 0, id 1, lun 0

How do I use BLIST_INQUIRY_36? Is there anything else I can try to fix this error?

Also, is there a searchable archive for this list?

Bowie