Hi all
I change the monitor to LG LCD
but x window couldn't start because of the "out of range" signal in the monitor
How can I fix this problem
Thank you
On Sat, Dec 31, 2005 at 02:33:53AM +0800, adrian kok enlightened us:
I change the monitor to LG LCD
but x window couldn't start because of the "out of range" signal in the monitor
How can I fix this problem
Run system-config-display as root.
Matt
Hi matt
thank you
but it is same problem as startx after running system-config-display
do u have any command to let the system to detect the monitor?
thank you
--- Matt Hyclak hyclak@math.ohiou.edu wrote:
On Sat, Dec 31, 2005 at 02:33:53AM +0800, adrian kok enlightened us:
I change the monitor to LG LCD
but x window couldn't start because of the "out of range" signal in the monitor
How can I fix this problem
Run system-config-display as root.
Matt
-- Matt Hyclak Department of Mathematics Department of Social Work Ohio University (740) 593-1263 _______________________________________________ CentOS mailing list CentOS@centos.org http://lists.centos.org/mailman/listinfo/centos
adrian kok adriankok2000@yahoo.com.hk wrote:
Hi all I change the monitor to LG LCD but x window couldn't start because of the "out of range" signal in the monitor How can I fix this problem
If there arescan ranges (Horiz/Vert) defined in the monitor section of /etc/X11/xorg.conf, remove them. The video card should detect and pass along the correct scan ranges. If they are explicitly defined, X will assume you know what you are doing. It's very likely your old monitor supports higher scan ranges than the new LCD.
Otherwise, pull out your manual for your LG monitor and put in the correct scan ranges in the Monitor section.
-
adrian kok -
Bryan J. Smith -
Matt Hyclak