Hi all I did a "yum install dcfldd" on Centos7.
I plugged in my USB HUb, plugged in 3 disks I want to duplicate Verified each disk plugged in run the command dcfldd if=myimg.img of=/dev/sdd of=/dev/sde of=/dev/sdf
No errors no nothing, Said "writing" the whole time - when done it said 8248Mb Written
But the image was not actually written to the three disks. It still just has a single partition - the default partition.
Am I doing something wrong ? Thanks,
Jerry
On Fri, Sep 03, 2021 at 12:58:14PM -0400, Jerry Geis wrote:
But the image was not actually written to the three disks. It still just has a single partition - the default partition.
Were the disks mounted when you wrote to them? Did you eject and re-insert them after writing to them?
Were the disks mounted when you wrote to them? Did you eject and re-insert them after writing to them
I do not have automount enabled. so no they were not mounted.
After writing to them - I did "fdisk -l /dev/sdd" and the partitioning was still the same as before doing the write.
Thanks,
Jerry
-
Jerry Geis -
Jonathan Billings