Hi Lijun, Make the prep build first to have .config in BUILD/<kernel>/<linux> (let's say config.org) Then, add CONFIG_USB_DWC3=m in config-centos-sig, run rpmbuild again. The error will occur as you said. Compare error item CONFIG_USB_DWC3_ULPI to config.org. If CONFIG_USB_DWC3_ULPI does not exist, add "#CONFIG_USB_DWC3_ULPI is not set" to config-centos-sig If CONFIG_USB_DWC3_ULPI=m, add "CONFIG_USB_DWC3_ULPI=m" to config-centos-sig If CONFIG_USB_DWC3_ULPI=y, add "CONFIG_USB_DWC3_ULPI=y" to config-centos-sig Do the same to the others. Best regards, Chuong. On Tue, Apr 5, 2016 at 10:51 PM, Lijun Pan <lijun.pan at nxp.com> wrote: > Add the mailing list. > Have any of you seen this similar issue before? > > > Thanks, > Lijun Pan > > ________________________________________ > From: Lijun Pan > Sent: Tuesday, April 5, 2016 10:09:16 AM > To: Jim Perrin > Subject: rpmbuild report newoptions error > > Hi Jim, > > When I enabled CONFIG_USB_DWC3=m in config-centos-sig > > rpmbuild has following errors > ====== > + '[' -s .newoptions ']' > + cat .newoptions > CONFIG_USB_DWC3_ULPI > CONFIG_USB_DWC3_PCI > CONFIG_USB_DWC3_DEBUG > + exit 1 > error: Bad exit status from /var/tmp/rpm-tmp.7mSfnd (%prep) > ===== > > While looking at my USB driver code, I did not enable or add those 3 > configuration. > Do you think it is a bug in the kernel-aarch64.spec? > Can we fix it somehow? > > Thanks, > Lijun > _______________________________________________ > Arm-dev mailing list > Arm-dev at centos.org > https://lists.centos.org/mailman/listinfo/arm-dev > -------------- next part -------------- An HTML attachment was scrubbed... URL: <http://lists.centos.org/pipermail/arm-dev/attachments/20160405/dc2b5e9e/attachment-0006.html>