Thanks, Chong. It works. Lijun From: arm-dev-bounces at centos.org [mailto:arm-dev-bounces at centos.org] On Behalf Of Chuong Tran Sent: Tuesday, April 05, 2016 11:03 AM To: Conversations around CentOS on ARM hardware <arm-dev at centos.org> Subject: Re: [Arm-dev] Fw: rpmbuild report newoptions error Hi Lijun, Make the prep build first to have .config in BUILD/<kernel>/<linux> (let's say config.org<http://config.org>) Then, add CONFIG_USB_DWC3=m in config-centos-sig, run rpmbuild again. The error will occur as you said. Compare error item CONFIG_USB_DWC3_ULPI to config.org<http://config.org>. If CONFIG_USB_DWC3_ULPI does not exist, add "#CONFIG_USB_DWC3_ULPI is not set" to config-centos-sig If CONFIG_USB_DWC3_ULPI=m, add "CONFIG_USB_DWC3_ULPI=m" to config-centos-sig If CONFIG_USB_DWC3_ULPI=y, add "CONFIG_USB_DWC3_ULPI=y" to config-centos-sig Do the same to the others. Best regards, Chuong. On Tue, Apr 5, 2016 at 10:51 PM, Lijun Pan <lijun.pan at nxp.com<mailto:lijun.pan at nxp.com>> wrote: Add the mailing list. Have any of you seen this similar issue before? Thanks, Lijun Pan ________________________________________ From: Lijun Pan Sent: Tuesday, April 5, 2016 10:09:16 AM To: Jim Perrin Subject: rpmbuild report newoptions error Hi Jim, When I enabled CONFIG_USB_DWC3=m in config-centos-sig rpmbuild has following errors ====== + '[' -s .newoptions ']' + cat .newoptions CONFIG_USB_DWC3_ULPI CONFIG_USB_DWC3_PCI CONFIG_USB_DWC3_DEBUG + exit 1 error: Bad exit status from /var/tmp/rpm-tmp.7mSfnd (%prep) ===== While looking at my USB driver code, I did not enable or add those 3 configuration. Do you think it is a bug in the kernel-aarch64.spec? Can we fix it somehow? Thanks, Lijun _______________________________________________ Arm-dev mailing list Arm-dev at centos.org<mailto:Arm-dev at centos.org> https://lists.centos.org/mailman/listinfo/arm-dev -------------- next part -------------- An HTML attachment was scrubbed... URL: <http://lists.centos.org/pipermail/arm-dev/attachments/20160405/e769dfc4/attachment-0006.html>