On 05/03/2016 11:56, Richard W.M. Jones wrote:
> On Sat, Mar 05, 2016 at 10:26:25AM +0700, Phong Vo wrote:
>> There should be no issue of replacing U-boot in SPI nor with the mp30ar0
>> Tianocore version.
>> But you need to use the mp30ar0_tianocore_media.img I provide, not the one
>> supplied
>> with the Mustang board. It was likely the person burn the wrong BIOS on
>> the board!
>>
>> You can burn the Tianocore image from U-boot using TFTP. Please check and
>> setup your U-boot
>> variables:
>>
>> media_addr_r=0x4001000000
>> media_img=mp30ar0_tianocore_media.img
>> spi_load=tftp ${media_addr_r} ${user_dir}/${media_img}
>> spi_update=sf probe 0; sf erase 0x0 ${filesize}; sf write ${media_addr_r}
>> 0x0 ${filesize}
> To be absolutely clear, the above are not u-boot commands? You have
> to use setenv and quote the parameters?
Yes, as Gordan pointed out, they are u-boot variables set with setenv.
> Second question: In the tarball you previously posted, the .img file
> is called 'mp30ar0_media.img' (not 'mp30ar0_tianocore_media.img'). Is
> that correct or is there a newer version somewhere?
I downloaded and use the contents of
https://dl.dropboxusercontent.com/u/20403943/mp30ar0_tianocore_binaries.tar.xz,
which are;
ls -al mp30ar0*
-rw-r--r-- 1 5008 345 620032 Jan 26 10:41 mp30ar0_media.img
-rw-r--r-- 1 5008 345 262144 Feb 22 04:41 mp30ar0_tianocore_sec_ubt.fd
-rw-r--r-- 1 5008 345 1835008 Feb 22 04:41 mp30ar0_tianocore_ubt.fd
> Third question: How do I set the MAC address in this TianoCore?
> RHEL booted up with MAC 00:00:00:00:00:00 which meant nothing else
> worked of course.
>
Once in the UEFI shell, use 'set MAC0 xx:xx:xx:xx:xx:xx' and 'set MAC1
xx:xx:xx:xx:xx:xx'
--
Mike Howard