[Arm-dev] Kernel problems on APM X-Gene

[Jeremiah Rothschild]

On Thu, Sep 21, 2017 at 11:52:40AM +0200, Marcin Juszkiewicz wrote:
> W dniu 21.09.2017 o 11:32, Jeremiah Rothschild pisze:
> > On Thu, Sep 21, 2017 at 04:19:55PM +0700, Phong Vo wrote:
> >> Jeremiah,
> > 
> > Hi Phong, thank you for the reply.
> > 
> >> Is this on Mustang board? Which version of bootloader are you using?
> > 
> > Pardon me for not being more specific. This is the Gigabyte MP30-AR0 board.
> > 
> > Using bootloader version:
> > U-Boot 2013.04-mp30ar0_sw_1.18.04 (Sep 02 2015 - 16:38:06) REV: F06b ( uart0 )
> 
> Have you considered moving to UEFI firmware?

I am a little hesitant to make changes since it is our only ARM development
box. I could look into it, though. Thanks for the suggestion.

> I can confirm that 4.11 works on X-Gene machine as it booted fine on HPe
> Moonshot m400 cartridge:

Hmm, interesting. Perhaps if I can figure out how to get the kernel booting
to actually display via video (or IPMI) then it would reveal an error
message. It has never shown output after GRUB but I imagine there's a way to
route it.

> [linaro at c8n1 ~]$ uname -a
> Linux c8n1 4.11.0-22.el7.2.aarch64 #1 SMP Thu Sep 14 17:01:49 CDT 2017
> aarch64 aarch64 aarch64 GNU/Linux
> 
> My APM Mustang is offline so can not check there.
> _______________________________________________
> Arm-dev mailing list
> Arm-dev at centos.org
> https://lists.centos.org/mailman/listinfo/arm-dev