I am experimenting with kvm on a quad x86_64 running CentOS-5.5. I have created my first virtual guest and it seems to run fine. Now I wish to assign that particular guest to a fixed, public IP address. There seems to be at least two ways to proceed and I am soliciting comments on the preferred approach. In the first instance I can use brctl to create a bridged 'shared physical device' and presumably add that device to the network configuration of the guest, assigning the IP connection details there. In the second, I can continue to use the virtual networking system, albeit with fixed private as opposed to DHCP assigned addresses. In this case I gather that I must use ifconfig to add public IP addresses to the eth0 interface of the host and use iptables to route the public to the private address. Firstly, are my inferences correct? Are there any other approaches that I cannot discern? If these are the only two methods then which is the preferred one? I get the sense that bridging works in a manner that permits only one guest to access that physical device, however the documentation is not explicit on the matter. I have looked extensively for guidance but I suspect that a great deal of what I have read is somewhat dated and likely to cause me more trouble than help. -- *** E-Mail is NOT a SECURE channel *** James B. Byrne mailto:ByrneJB at Harte-Lyne.ca Harte & Lyne Limited http://www.harte-lyne.ca 9 Brockley Drive vox: +1 905 561 1241 Hamilton, Ontario fax: +1 905 561 0757 Canada L8E 3C3