[CentOS] scsi tape device support
Marc Peiser
marcpeiser at gmail.com
Wed Dec 14 09:03:38 UTC 2005
On 13/12/05, Bryan J. Smith <thebs413 at earthlink.net> wrote:
>
> Marc Peiser <marcpeiser at gmail.com> wrote:
> > I'm trying to get a scsi tape device (Sony SDX-D500V)
> > working on my dell 2450 running centos 4.2. I can see the
> > device (ch1, id2) using the dell bois raid utility, but
> > once booted into linux I can't see any mention of it in
> > the logs or dmesg.
>
> Is it the same SCSI controller as the SCSI disks?
> Are the SCSI disks in a hardware RAID configuration?
Yes, you're right. I'm using the onboard scsi controller. Channel/scsi 0 has
5 disks (id 0-4) in RAID 5 configuration, the tape drive is connected to the
channel 1, id 2.
Just FYI, some Linux drivers for SCSI cards with RAID only
> have disk/block support, and not more advanced support for
> rich peripherals like optical/tape on the same controller.
>
> [ I don't know if that is your case, I haven't researched
> your Dell model/configuration. ]
Just had another look at the output from dmesg and see the following:
SCSI subsystem initialized
ACPI: PCI interrupt 0000:05:04.0[A] -> GSI 31 (level, low) -> IRQ 217
ACPI: PCI interrupt 0000:05:04.1[B] -> GSI 30 (level, low) -> IRQ 225
scsi0 : Adaptec AIC7XXX EISA/VLB/PCI SCSI HBA DRIVER, Rev 6.2.36
<Adaptec aic7899 Ultra160 SCSI adapter>
aic7899: Ultra160 Wide Channel A, SCSI Id=7, 32/253 SCBs
scsi1 : Adaptec AIC7XXX EISA/VLB/PCI SCSI HBA DRIVER, Rev 6.2.36
<Adaptec aic7899 Ultra160 SCSI adapter>
aic7899: Ultra160 Wide Channel B, SCSI Id=7, 32/253 SCBs
megaraid cmm: 2.20.2.6 (Release Date: Mon Mar 7 00:01:03 EST 2005)
megaraid: 2.20.4.6 (Release Date: Mon Mar 07 12:27:22 EST 2005)
megaraid: probe new device 0x101e:0x1960:0x1028:0x0493: bus 2:slot 0:func 0
ACPI: PCI interrupt 0000:02:00.0[A] -> GSI 18 (level, low) -> IRQ 193
megaraid: fw version:[1.57] bios version:[3.13]
scsi2 : LSI Logic MegaRAID driver
scsi[2]: scanning scsi channel 0 [Phy 0] for non-raid devices
Vendor: DELL Model: 1x5 U2W SCSI BP Rev: 1.30
Type: Processor ANSI SCSI revision: 02
scsi[2]: scanning scsi channel 1 [Phy 1] for non-raid devices
scsi[2]: scanning scsi channel 2 [virtual] for logical drives
Vendor: MegaRAID Model: LD0 RAID5 38712R Rev: 1.57
Type: Direct-Access ANSI SCSI revision: 02
SCSI device sda: 284082176 512-byte hdwr sectors (145450 MB)
sda: asking for cache data failed
sda: assuming drive cache: write through
sda: sda1 sda2
Attached scsi disk sda at scsi2, channel 2, id 0, lun 0
kjournald starting. Commit interval 5 seconds
EXT3-fs: mounted filesystem with ordered data mode.
Attached scsi generic sg0 at scsi2, channel 0, id 6, lun 0, type 3
Attached scsi generic sg1 at scsi2, channel 2, id 0, lun 0, type 0
I'm not sure what this means, but looks to me like LSI Logic MegaRAID driver
should find my tape device. Is that correct?
> Do you know if the generic kernel (2.6.9-22.0.1.ELsmp)
> > supports this tape device?
>
> Yes. But I think you're issue is something else (as above).
>
> > Can anyone give me any pointers in getting this
> > device working.
>
> If you do an "lsmod", we can find out more about your SCSI
> controller.
[root at vindaloo ~]# lsmod
Module Size Used by
md5 8001 1
ipv6 240097 28
autofs4 22085 0
i2c_dev 14273 0
i2c_core 25921 1 i2c_dev
sunrpc 139173 1
microcode 11873 0
dm_mod 58949 0
button 10449 0
battery 12869 0
ac 8773 0
ohci_hcd 23889 0
tg3 85061 0
e100 38209 0
mii 8641 1 e100
floppy 58065 0
sg 38113 0
ext3 118729 1
jbd 59481 1 ext3
megaraid_mbox 37073 2
megaraid_mm 17905 1 megaraid_mbox
aic7xxx 146425 0
sd_mod 20545 3
scsi_mod 116429 4 sg,megaraid_mbox,aic7xxx,sd_mod
[root at vindaloo ~]#
Now if your tape is attached to a different controller (not
> just a different channel on the same controller) than your
> disks, then it's probably just the fact the SCSI driver isn't
> loaded.
>
> In either case, I need to know what disk controller.
Yes, same controller, different channel. I've included the output of dmesg
for you to look at.
Thanks for your help.
--
> Bryan J. Smith | Sent from Yahoo Mail
> mailto:b.j.smith at ieee.org | (please excuse any
> http://thebs413.blogspot.com/ | missing headers)
> _______________________________________________
> CentOS mailing list
> CentOS at centos.org
> http://lists.centos.org/mailman/listinfo/centos
>
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.centos.org/pipermail/centos/attachments/20051214/9191a749/attachment.html>
-------------- next part --------------
A non-text attachment was scrubbed...
Name: dmesg.out
Type: application/octet-stream
Size: 14672 bytes
Desc: not available
URL: <http://lists.centos.org/pipermail/centos/attachments/20051214/9191a749/attachment.obj>
More information about the CentOS
mailing list